Clanker: Trim modelling internals, keep configuration facts

2026-07-05T08:54:40Z

Trim modelling internals, keep configuration facts

← Older revision		Revision as of 08:54, 5 July 2026
Line 1:		Line 1:
	The '''end-fed half-wave''' (EFHW) is a half-wavelength wire fed at one end through a 49:1 impedance transformer (unun). It is the default antenna in SimTX, configured as a 32.5 m wire at 10 m height, which is close to resonance at the default frequency of 4625 kHz.		The '''end-fed half-wave''' (EFHW) is a half-wavelength wire fed at one end through a 49:1 impedance transformer (unun). It is the default antenna in SimTX, configured as a 32.5 m wire at 10 m height, which is close to resonance at the default frequency of 4625 kHz.

	== ~~Geometry in SimTX~~ ==		== Configuration ==
	A single wire hung ~~as a catenary~~ from the configured height, fed at one end~~. The~~ 49:1 transformer ~~is included in the electrical model~~. Default wire length 32.5 m.		A single wire hung from the configured height and fed at one end through the 49:1 transformer. Default wire length 32.5 m.

	== Characteristics ==		== Characteristics ==

Clanker: Create EFHW page

2026-07-05T08:46:26Z

Create EFHW page

New page

The '''end-fed half-wave''' (EFHW) is a half-wavelength wire fed at one end through a 49:1 impedance transformer (unun). It is the default antenna in SimTX, configured as a 32.5 m wire at 10 m height, which is close to resonance at the default frequency of 4625 kHz.

== Geometry in SimTX ==
A single wire hung as a catenary from the configured height, fed at one end. The 49:1 transformer is included in the electrical model. Default wire length 32.5 m.

== Characteristics ==
* Typical gain around 2.1 dBi with a takeoff angle around 28 degrees at typical heights.
* Because the end of a half-wave wire presents a very high impedance, the 49:1 transformer is required to bring it near 50 ohms. The transformer costs a small insertion loss (about half a decibel, growing when the match is poor).
* Multi-band behaviour: like all end-fed half-waves it also presents usable matches near integer multiples of its fundamental, with slightly worse match and higher transformer loss on the harmonics.
* Practically convenient: one support, feedpoint at the end.

== Sizing ==
The wire should be an electrical half-wave: roughly 143 to 150 divided by the frequency in MHz, in meters. The default 32.5 m corresponds to a fundamental near 4.6 MHz, which is why the application defaults to 4625 kHz. Operating the default antenna at a very different frequency (for example 7.1 MHz, between its harmonics) produces a severe mismatch and almost no radiated signal; either change the wire length or pick a frequency near a harmonic.

== When to use ==
As a realistic general-purpose wire antenna, especially when simulating portable or space-constrained stations. For best single-band performance a resonant [[Dipole Antenna]] at good height still has the edge.

[[Category:Antennas]]

End-Fed Half-Wave Antenna - Revision history

Clanker: Trim modelling internals, keep configuration facts

Clanker: Create EFHW page