Editing SimTX API/Packets/TxTelemetry (section)

== Fields ==
{| class="wikitable"
! # !! Field !! Type !! Description
|-
| 1 || <code>sequence</code> || <code>int64</code> || Increments with each telemetry frame. Telemetry is coalesced, so values may be skipped.
|-
| 2 || <code>server_time_ms</code> || <code>int64</code> || Server wall clock, Unix ms.
|-
| 3 || <code>actual_frequency_hz</code> || <code>double</code> || Frequency on air in Hz: the requested frequency plus the frequency offset.
|-
| 4 || <code>requested_power_watts</code> || <code>float</code> || Power requested, after the PA cap.
|-
| 5 || <code>forward_power_watts</code> || <code>float</code> || Power leaving the amplifier towards the antenna.
|-
| 6 || <code>delivered_power_watts</code> || <code>float</code> || Power accepted by the antenna.
|-
| 7 || <code>reflected_power_watts</code> || <code>float</code> || Power reflected by the mismatch.
|-
| 8 || <code>vswr</code> || <code>float</code> || Voltage standing-wave ratio at the feed point.
|-
| 9 || <code>mismatch_loss_db</code> || <code>float</code> || Loss due to the mismatch, dB.
|-
| 10 || <code>transformer_loss_db</code> || <code>float</code> || Loss in the matching transformer, dB.
|-
| 11 || <code>foldback_loss_db</code> || <code>float</code> || Power reduction by SWR protection, dB.
|-
| 12 || <code>alc_db</code> || <code>float</code> || Automatic level control reduction, dB.
|-
| 13 || <code>buffer_seconds</code> || <code>float</code> || Samples waiting in the server's playout buffer, seconds.
|-
| 14 || <code>finals_temperature_c</code> || <code>float</code> || Temperature of the final amplifier, °C.
|-
| 15 || <code>thermal_foldback_db</code> || <code>float</code> || Power reduction by thermal protection, dB.
|-
| 16 || <code>pa_compression_db</code> || <code>float</code> || Amplifier gain compression, dB.
|-
| 17 || <code>pa_heat_watts</code> || <code>float</code> || Heat dissipated in the amplifier, W.
|-
| 18 || <code>pa_efficiency_percent</code> || <code>float</code> || Amplifier efficiency, percent.
|-
| 19 || <code>pa_thermal_fault_active</code> || <code>bool</code> || True while the amplifier is in thermal fault.
|}