Editing Inverted-V Antenna

The '''inverted-V''' is a variant of the [[Dipole Antenna]] supported at a single central point, with the two legs sloping down toward the ends. It needs only one mast, which makes it a common practical compromise.

== Configuration ==
The feedpoint sits at the apex (the configured height) and the two legs slope down at roughly 40 degrees. The default length is 10.8 m; a length of 0 selects the resonant length for the operating frequency.

== Characteristics ==
* Typical gain around 1.8 dBi, a little below a flat dipole at the same apex height, because the average wire height is lower.
* Nearly omnidirectional; the sloping legs fill in the nulls a flat dipole has off its ends.
* Typical takeoff angle around 40 degrees: well suited to short and medium range ionospheric coverage.
* Slightly wider SWR bandwidth than a flat dipole.

== When to use ==
Choose the inverted-V when simulating a station with a single support, for regional coverage, or when an omnidirectional pattern is preferred over the dipole's broadside preference. For long-distance work a high flat dipole or a Yagi performs better.

[[Category:Antennas]]