Jump to content

Dipole Antenna: Difference between revisions

From SimTX Wiki
Clanker (talk | contribs)
Trim modelling internals, keep configuration facts
Clanker (talk | contribs)
Rework documentation for new users: illustrated steps, clear navigation, preserved technical references, and current 0.3.6 behavior
 
Line 1: Line 1:
{{Documentation navigation}}
The '''dipole''' is a half-wave wire antenna fed at its center. It is the classic reference antenna for HF work: simple, predictable and effective.
The '''dipole''' is a half-wave wire antenna fed at its center. It is the classic reference antenna for HF work: simple, predictable and effective.
== Try this antenna ==
Use it as a general-purpose HF starting point. Set frequency, estimate total wire length with 143 / MHz, then check SWR. Azimuth describes the wire direction; the strongest lobes are generally broadside to it, not off its ends.
[[Antenna System|Compare antenna types and tuning steps]] · [[Antenna Calculations|Calculate a starting length]] · [[Propagation Basics|Understand the coverage]]


== Configuration ==
== Configuration ==
The wire runs horizontally along the azimuth direction and is fed in the center. The default wire length is 10.1 m; a length of 0 selects the resonant half-wave length for the operating frequency automatically.
The wire runs horizontally along the azimuth direction and is fed in the center. The default wire length is 10.1 m; a length of 0 selects a nominal half-wave geometry for the operating frequency. Adjust it if the solved SWR is high.


== Characteristics ==
== Characteristics ==
Line 16: Line 24:


== Sizing ==
== Sizing ==
A practical resonant half-wave length in meters is approximately 143 divided by the frequency in MHz (see [[Antenna Calculations]]). Examples: about 40 m at 3.6 MHz, about 20 m at 7.1 MHz, about 10 m at 14.2 MHz. Leaving the length at 0 lets SimTX use the resonant length directly.
A practical resonant half-wave length in meters is approximately 143 divided by the frequency in MHz (see [[Antenna Calculations]]). Examples: about 40 m at 3.6 MHz, about 20 m at 7.1 MHz, about 10 m at 14.2 MHz. A length of 0 uses a nominal half wavelength, which differs from this shortened starting length and can have a higher SWR.


== When to use ==
== When to use ==

Latest revision as of 21:21, 13 September 2026

The dipole is a half-wave wire antenna fed at its center. It is the classic reference antenna for HF work: simple, predictable and effective.


Try this antenna[edit | edit source]

Use it as a general-purpose HF starting point. Set frequency, estimate total wire length with 143 / MHz, then check SWR. Azimuth describes the wire direction; the strongest lobes are generally broadside to it, not off its ends.

Compare antenna types and tuning steps · Calculate a starting length · Understand the coverage

Configuration[edit | edit source]

The wire runs horizontally along the azimuth direction and is fed in the center. The default wire length is 10.1 m; a length of 0 selects a nominal half-wave geometry for the operating frequency. Adjust it if the solved SWR is high.

Characteristics[edit | edit source]

  • Typical gain around 5.5 dBi over ground, broadside to the wire (peaks perpendicular to the wire run).
  • Non-directional in practice: a figure-eight pattern with broad lobes and shallow nulls off the wire ends.
  • Typical takeoff angle around 30 degrees at the default 10 m height. Radiation angle depends strongly on height, see below.
  • Moderate bandwidth: SWR stays reasonable over several percent of the center frequency; odd multiples of the resonant frequency are also usable.

Height[edit | edit source]

Height above ground is the dominant tuning knob:

  • Below roughly a quarter wavelength, the dipole radiates mostly straight up. That is excellent for short-range regional coverage (a few hundred kilometers via near-vertical ionospheric reflection) and poor for long distance.
  • Around half a wavelength and above, a strong low-angle lobe forms and long-distance performance improves markedly.

Sizing[edit | edit source]

A practical resonant half-wave length in meters is approximately 143 divided by the frequency in MHz (see Antenna Calculations). Examples: about 40 m at 3.6 MHz, about 20 m at 7.1 MHz, about 10 m at 14.2 MHz. A length of 0 uses a nominal half wavelength, which differs from this shortened starting length and can have a higher SWR.

When to use[edit | edit source]

A resonant dipole at a sensible height is a strong general-purpose choice on any HF band and a good baseline against which to compare other antennas.